1>.Portable ultrasonic welding machine has a wide range of applicability, with spot drilling and spot welding function, simple operation, easy to carry, small volume does not occupy space; Is one of the many manufacturers like small equipment. Brief introduction to the understanding and using method of using portable ultrasonic welding machine
Portable ultrasonic welding machine has a wide range of applicability, with spot drilling and spot welding function, simple operation, easy to carry, small volume does not occupy space;
A, portable ultrasonic welding machine structure principle:
1. High quality imported ultrasonic transducer, strong power, good stability.
2. The whole machine design exquisite, small volume does not occupy space.

3.800W higher power and stronger output than ordinary other products.

2>.Portable ultrasonic spot welding machine installation matters:
1. Connect one end of the cable to the output control cable connector on the vibration cylinder, and connect the other end to the output control cable socket on the back of the electrical box, and tighten the wire plug.
2. Wipe the connection surface of the welding head, connect it to the transducer of the vibration cylinder, and lock it with a wrench. Note: when connecting, ensure that the welding head is replaced
The two connecting surfaces between the energy devices are anastomosed and locked. The connection screw is too long or the sliding tooth cannot be locked, otherwise the sound wave will not be transmitted
Free and cause the machine damage.
3, when loading and unloading the welding head, two spanners must be used to lock the welding and the transducer respectively, not only one part of the lock or loading and unloading, so as not to cause
Damage to portable vibrator cylinder.
4, check 1 and 2 points are properly installed, plug the power cord socket in the external power socket, and turn the power switch, then the power indicator is on.
5, light pressure acoustic wave control switch, then you can hear the sound wave transmitted to the welding head "squeak" sound, indicating that the machine works normally, can
Put into use.
6. When the machine is working abnormally, do not disassemble the equipment without permission.

3>.Portable ultrasonic welding machine use matters:
1: ultrasonic direct use of 220V mains, so the body should be properly grounded before power, grounding resistance should be less than 4 ohms.
2: when the voltage change of mains is greater than 10%, ac voltage regulator should be installed on the machine to ensure the efficient and safe operation of ultrasonic welding machine.
3: After the power, do not put the hand under the upper welding die, to avoid high-frequency vibration and high pressure damage.
4: ultrasonic sound, shall not make the upper welding die contact with the lower welding die, fixture and workbench, in order to avoid damage to parts.
5: before ultrasonic welding, we must first do acoustic detection, especially the replacement of the welding die, this operation can not be neglected.
6: welding mold design, processing, adjustment, otherwise it will damage the ultrasonic energy exchange system of the welding machine.
7: pneumatic system for plastic products, the pressure imposed by the external air source should not be greater than 0.5mpa, otherwise it will cause blasting or lead to burning machine.
8: Ultrasonic welding frequency drop will produce audible noise, it is recommended that long-term operators should wear ear protector.