When the rubber cutting machine is working, if the cutting rubber head moves, it is difficult to ensure that the upper and lower rubber heads are on the same axis. A slight deviation of the rubber optical path will result in a large error. At the same time, the moving rubber head must be strongly cooled and smoke exhausted. During this process, it is easy to generate vibration and bring errors.

In order to avoid the accumulated error caused by the movement of the rubber device, the design of the two-dimensional operation of the worktable where the workpiece is located is carried out by fixing the rubber head, and the operation is carried out under the control of the computer, which not only ensures the stability of the cutting optical path, but also ensures the cutting The consistency of the seam and the precision of the overall graphic vein indicator. Interference of the optical path is avoided, while the rubber tip is easy to track.

The production of die-cutting boards has relatively high requirements for cutting seams. The adjustable range of the slit width of rubber cutting has certain limitations. For CO2 rubber cutting wood panels, the range is usually only 0.30-0.71mm. For slits with a width of more than 0.71mm, it is difficult to complete the cutting. Use the method of offsetting the center of the slit twice to complete the index requirements.

In the test, if the rubber focal points of the rubber heads of the upper and lower Cologne mass flow meters face the surface of the workpiece, the cutting seam is the smallest and the cutting performance is the best. If you need to increase the width of the slit, you can use positive focus to make the slit wider, but the cutting ability will decrease accordingly.